How to Build a Balance Board

Last Updated: April 10, 2021

Balance boards are becoming a popular way to build core strength and balancing skills. By trying to stand on an unstable surface, you exercise the parts of your body and your brain that control balance. If you want one but don't have $100 to spend, simply build your own!

Steps

1
Figure out what size board you want. This will depend mostly on how tall you are. The board should be long enough so that you can have a wide, shoulder-width stance while riding it. It should also be wide enough so that your feet won't hang off the sides. Around 33" by 14" is good.^{[1]
X
Research source}
2
Purchase a piece of 3/4" plywood big enough to cut down to the size you want the board to be with some extra. Also purchase some large diameter, (5" to 7" is good), thick walled PVC or ABS pipe. It should be long enough to fit the width of your board, and strong enough that it does not flex easily, since you will be putting your weight on it.^{[2]
X
Research source}

Advertisement
3
Cut the plywood to size, and the PVC, if needed.
4
Using the excess plywood, cut 2 pieces, each about 2 inches (5.1 cm) wide and 14 inches (35.6 cm) (width of board) long.^{[3]
X
Research source}
5
Secure these two pieces at either end of the board, on the same side of the board, for stoppers. Use these for safety if you think you will hurt yourself, otherwise you don't need them. These will help the board not slip off the end of the pipe while riding.^{[4]
X
Research source}
6
Lay the pipe on the floor and place the board on top of it. Put on a safety helmet, wrist guards, elbow and knee pads. Again, you only need these if you think you might get hurt. Step on the board carefully, (using a chair or someone's shoulder for support, at least the first few times), and test your balance!^{[5]
X
Research source}
7
Finished.

Warnings

Do not try tricks that are too advanced for you.

⧼thumbs_response⧽
Helpful 4 Not Helpful 1
Always wear your safety gear, consisting of helmet, wrist guards, elbow and knee pads, while riding a balance board.

⧼thumbs_response⧽
Helpful 1 Not Helpful 0
Only ride your homemade balance board in an open area. Make sure there is enough room to fall off of it safely.

⧼thumbs_response⧽
Helpful 1 Not Helpful 0
The PVC should roll underneath the board but not away from it because of the stoppers. Nevertheless, sudden, jerky movements could result in the board becoming separated from the pipe, so be careful.

⧼thumbs_response⧽
Helpful 1 Not Helpful 2