You might not think about it too often, but the inside of your laptop does get dusty and dirty over time. When it comes to the life span and performance of a laptop, cleaning it regularly does make a difference.

Steps

  1. 1
    Make sure the laptop is switched off and take the battery out.
  2. 2
    Unscrew only the screws relevant for the particular part of the laptop you are trying to disassemble. There are signs engraved right under or beside the screw as a guide.
    Advertisement
  3. 3
    Take all the relevant screws out.
  4. 4
    Gently remove the touch pad portion and disconnect its wire from the laptop.
  5. 5
    Gently lift the keyboard and also disconnect it from the laptop.
  6. 6
    Take your can of compressed air and spray all over the laptop. Concentrate the most on the fan, processor and memory.
    • You should always keep the compressed air at a 90-degree angle upwards. If you turn it in any direction and orientation, the compressed air will actually spit out the hydrogen and it will turn into ice.
    • Get a strong nozzle to pinpoint the direction that the air is coming out of, always aiming it into open vent ports.
  7. 7
    Review the results. Once done, the inside of a laptop should look like this.
  8. 8
    Put everything back the way it was. Make sure you gently press the connector of a keyboard to connect it to the laptop as well as the touch pad.
  9. 9
    Screw again the back of a laptop in the same order.
  10. 10
    Enjoy your clean laptop!
  11. Advertisement

Community Q&A

  • Question
    Can I use water instead? That's the only thing I have.
    Community Answer
    Community Answer
    It's not advisable to use water, as you could seriously damage your computer. Compressed air is best.
  • Question
    Can I use a vaccum cleaner to do that?
    Neel Jahan
    Neel Jahan
    Community Answer
    You can try, but it won't really do much good, as the normal vacuum cleaner has a very broad nose.
  • Question
    How often should I clean my laptop? I usually use it indoors, and I live in a tropical rainforest country.
    Gary
    Gary
    Community Answer
    The location of the device doesn't matter as much internally. It is dust that normally coats the hardware like fans. If fans aren't able to circulate the airflow well enough, then it will heat the hardware and that could slow it down and even create damage. So, aim to clean it out every 6 months to a year. It depends on how well you cleaned it out last time.
Advertisement

Warnings

  • Make sure to shut down the computer and remove the battery before attempting to take it apart.
    ⧼thumbs_response⧽
Advertisement

Things You'll Need

  • Dust removal spray
  • Small Phillips screwdriver

About This Article

Yaffet Meshesha
Co-authored by:
Computer Specialist
This article was co-authored by Yaffet Meshesha. Yaffet Meshesha is a Computer Specialist and the Founder of Techy, a full-service computer pickup, repair, and delivery service. With over eight years of experience, Yaffet specializes in computer repairs and technical support. Techy has been featured on TechCrunch and Time. This article has been viewed 49,869 times.
How helpful is this?
Co-authors: 8
Updated: February 26, 2023
Views: 49,869
Advertisement