This article was co-authored by Katie Gohmann. Katherine Gohmann is a Professional Gardener in Texas. She has been a home gardener and professional gardener since 2008.
wikiHow marks an article as reader-approved once it receives enough positive feedback. This article received 13 testimonials and 89% of readers who voted found it helpful, earning it our reader-approved status.
This article has been viewed 349,500 times.
Geraniums will grow tall and leggy if they're not pruned regularly. Cutting back the plants allows for new growth and longer-lasting blooms, bringing out the best in these bright, cheerful garden staple. And you don't have to let the cuttings go to waste - you can use them to start new geranium plants. See the article below for information on knowing the right time to prune, trimming correctly, and propagating the cuttings.
Steps
Knowing When to Prune
-
1Pinch geraniums as soon as you bring them home. When you buy a new pot or flat of geraniums, pruning them immediately will encourage them to grow in a full, round, bushy shape. Be sure to remove dead flowers as well as any unhealthy leaves.[1]
- Geraniums come in two varieties: "true" and "common." True geraniums are perennials, so pruning them is a good investment. Common geraniums are annuals, and they also do well with pruning, but since they won't last more than a season, it's not absolutely necessary to prune them.
-
2Prune geraniums in preparation for winter. After the growing season is finished, pruning back the geraniums will help them stay healthy and dormant during the colder months. Wait until the flowers have died and the geranium has gotten a little leggy, in late summer or early to mid-fall. This way the geraniums will conserve energy during the winter and spring back to life when the weather gets warm.
- If you live in a temperate climate where the winters don't get so cold that the ground freezes, you can overwinter your geraniums outside.
- In colder areas, where the ground freezes hard, you'll want to dig up your geraniums and keep them in pots indoors for the winter.
Advertisement -
3Prune overwintered geraniums in the spring. The geraniums will have continued to grow over the winter, sprouting long, woody legs. It's not a very attractive look, and that's why geraniums should be pruned right at the beginning of the new growing season. This will encourage them to grow in a full, pretty shape as the weather gets warm.
- If you overwintered your geraniums outside, prune in late March or early April, when the weather begins to warm up.
- If you overwintered your geraniums inside, wait until the ground has thawed. You can gradually get them used to outdoor weather by putting them outside during sunny, warm days and bringing them back in at night. When the last frost has passed, you can either transplant them to the ground or keep them outside in pots.
Using the Right Trimming Technique
-
1Examine the plant. Take a look at the plant from all angles so you can identify problem areas. Look for areas where there aren't many leaves, dead areas, and lopsided areas. Determine where you'll need to prune in order to give your geranium a healthier and more attractive shape.
- Pruning actually spurs new growth of stems and flowers, so trimming back a particular place won't necessarily leave a hole.
- If a large part of the plant is dead, you'll need to do some drastic trimming. The plant should survive as long as the central stalk is still green. However, it might take a few weeks before new leaves and flowers emerge.
-
2Deadhead the spent blossoms. This pruning method is an important way to encourage the plant to create new flowers. Taking off the dead blossoms allows the geranium to direct energy toward producing new ones. It also clears your view of the plant's stalks, so you can better see what you're working with. You can deadhead your geranium any time you see languishing blossoms; it's a quick way to maintain the health of the plant, and doesn't even require tools.
- Grasp the flower stem just behind the dead blossom with your thumb and forefinger.
- Pinch the stem and sever it with your thumbnail, then discard the dead flower.
- Alternatively, you may want to wait until a whole flower cluster is spent, then remove the whole cluster further down the stem down at the next leafy area.
-
3Remove dead foliage. The next step is to get rid of dead or dying leaves and stems. Trimming them back will keep the plant from wasting energy trying to keep them alive. Use a pair of hand clippers to trim dead or dying stems to the base of the plant. This is an important step to take in the spring in order to encourage good growth during the growing season, but you can trim back dead foliage any time of year.[2]
- Don't bother trying to save foliage that seems on the verge of being dead, even if it's not quite there yet. It's better to trim it back and let the plant produce strong, new stems.
-
4Trim healthy flower stems. In the spring, trimming back healthy flower stems will encourage the plant to produce more flowers. Follow a flower stem to where it's joined to the main stem, then use a pair of hand clippers to trim it against the base of the main stem. This will activate dormant buds and you should see new growth in no time.
- If you don't want to make such a drastic cut, follow the flower stem back to 1⁄4 inch (0.6 cm) above the top of a node, which is a ring around the stem on a geranium. The new growth will sprout from the node.
-
5Trim back leggy stalks. "Leggy" stalks refer to those that have grown long and tall without any leaves, or with just a few leaves. Trimming these back almost to the base of the plant will allow it to produce new growth low down, creating a fuller, bushier look. Use a pair of hand trimmers to cut the stems close to the base, 1⁄4 inch (0.6 cm) above the lowest node. Keep the cuttings for propagation!
- At the end of the growing season, trim back at least 1/3 of the plant in this way to prepare it for winter dormancy.
Propagating the Cuttings
-
1Trim the bottom of the cuttings. Hold a cutting upright and find the lowest node. Trim to 1⁄4 inch (0.6 cm) below the node. Be sure to keep track of which end is up, since cuttings won't grow if you plant them upside down.
- Long cuttings can be trimmed into more than one piece. Just make sure each one is trimmed to 1⁄4 inch (0.6 cm) below a node.
- Cuttings from flowering branches usually will not root, because they don't have the correct hormones in them to create roots. The cuttings need to be from growing stems, not from flowering ones.
-
2Remove all but the top leaf. The cutting won't be able to support all of the leaves of first, but keeping one will help the growth process along. Trim off the dead or dying leaves and try to keep one healthy leaf toward the top.
- If the cutting doesn't have a leaf, you can still plant it.
- If the cutting has one large, healthy leaf, use a scissors to make a slit in the leaf, leaving both halves attached. A cutting can't support the surface area of a large leaf.
-
3Fill a small pot with soilless mix. You shouldn’t plant cuttings in regular potting soil, as it will remain too wet and rot the roots. Choose one part coconut coir, peat moss, or vermiculite and mix it with one part perlite or sterile builders sand. You'll need a separate plastic or clay container for each cutting you want to plant.[3]
-
4Dust cuttings with root hormones. Root hormones will help your geranium cutting flourish. Dip the bottom 1/4 inch (.64 cm) of the stem into rooting hormone and dust off the excess powder. You can find root hormones at the local garden shop, or online.[4]
-
5Plant the cutting. Use a chopstick or pen to make a hole in the potting soil, then insert the cutting bottom-side down. The tip of the cutting, including the leaf, should extend above the soil. Pat the soil lightly around the cutting.
-
6Water the cutting and wait for it to take root. After a week or two, it will begin to form roots. A few weeks later, new growth will appear. At this point, repot the cutting in garden or potting soil, or plant it in the ground.
Expert Q&A
Did you know you can get expert answers for this article?
Unlock expert answers by supporting wikiHow
-
QuestionI have a good size bush which is growing lots of flower stems, but the flowers shrivel and die before blooming. What is going wrong?Katie GohmannKatherine Gohmann is a Professional Gardener in Texas. She has been a home gardener and professional gardener since 2008.
Professional Gardener -
QuestionHow do I remove the dead blossoms - do you remove the whole head or pull off the small petals like you do for petunias?Katie GohmannKatherine Gohmann is a Professional Gardener in Texas. She has been a home gardener and professional gardener since 2008.
Professional Gardener -
QuestionDo geraniums grow well in pots?Community AnswerYes, they do!
References
About This Article
To prune geraniums, start by pinching off any dead blossoms, which encourages the plant to produce new flowers. Then, use hand clippers to trim dead or dying stems at the base of the plant. Next, trim back some of the healthy flower stems to where they’re connected to the main stem, so dormant buds will be activated and produce even more flowers. Finally, find any “leggy” stalks that have grown long and tall with few or no leaves, and cut them to the base of the plant to stimulate new growth and create a fuller, bushier geranium. For tips from our Horticultural reviewer on how to prune new geraniums, and when to prune more mature plants, scroll down!