How to Grow Lotus Flower

Co-authored by Maggie Moran and Jennifer Mueller, JD

Last Updated: February 1, 2023 References Approved

Sacred to Hindus and Buddhists, the Lotus is the national flower of India. This hardy aquatic plant is native to southern Asia and Australia, but they can be grown in nearly any temperate climate under the right conditions. You can grow lotus from seeds or from tubers. If you grow lotus from seeds, they typically will not flower in their first year.^{[1]
X
Research source}

Method 1

Method 1 of 3:

Growing from Seed

1
Scrape the seed with a file. Using a standard metal file, scrape the hard seed casing to reveal the cream-colored core. Do not file any of the core away or else your lotus will not grow. Filing away the outer casing allows water to reach the core.^{[2]
X
Research source}
- If you don't have a metal file handy, you can use any sharp knife or even rub the seed against concrete. Just be careful not to scrape away too much of the seed.
2
Place your seeds in warm water. Use a glass or transparent plastic container so that you can see when the seeds start to sprout. Fill the container with dechlorinated water between 75 and 80 °F (24 and 27 °C).^{[3]
X
Research source}
- After a day of soaking, the seeds will sink to the bottom and swell to nearly twice their original size. Seeds that float are almost always infertile. Remove them or they will cloud up the water.
- Change the water daily, even after the seeds have started to sprout. When you remove the seedlings to change the water, treat the sprouts with care – they are very delicate.
Advertisement
3
Fill a 3 to 5 US gal (11 to 19 L) container with 6 in (15 cm) of deep soil. This size typically provides enough room for a young lotus to grow. A black plastic bucket will retain heat to better warm the seedlings.^{[4]
X
Research source}
- Ideally, your soil should be 2 parts clay and 1 part river sand. If you use commercial potting soil to topsoil for houseplants, it will float to the surface once you submerge your tub in water.^{[5]
  X
  Research source}
- Make sure the container you choose does not have any drainage holes. The plant may gravitate toward the drainage hole and begin growing outside of it, causing the plant to underperform.
4
Remove seedlings from water once they are 6 inches (15 cm) long. Your seeds should start to sprout after 4 or 5 days of soaking. However, if you transfer them to the potting container to early, they will likely fail.^{[6]
X
Research source}
- If you wait too long, your seedlings will start to grow leaves. You can still plant them – just take care to keep the leaves free of the soil.^{[7]
  X
  Research source}
5
Press the sprouted seeds into the soil about 4 inches (10 cm) apart. You don't have to bury the seeds in the soil. Set them just on top, then brush a light layer of soil over them to secure them. They will take root on their own.^{[8]
X
Research source}
- It can be a good idea to wrap a small amount of modeling clay around the bottom of each seed to anchor it with a little weight. When you lower your container into the pond, an unanchored seed may find its way out of the soil and float up to the surface of the water.
6
Lower the pot into your pond. Lotus are aquatic plants, so the soil should always have at least 2 to 4 inches (5.1 to 10.2 cm) of water above it. If you have taller plants, the water can be up to 18 inches (46 cm) deep. Dwarf lotus need water between 2 and 12 inches (5.1 and 30.5 cm) deep.^{[9]
X
Research source}
- The water should be at least 70 °F (21 °C). If you live in an area with a relatively cooler climate, shallower water will provide extra warmth for your lotus.
- Lotus grown from seed rarely bloom in their first year. You should also keep fertilizer to a minimum during this first year. Allow your lotus to acclimate to its environment.

Method 2

Method 2 of 3:

Growing from Tuber

1
Purchase tubers in early spring. You can buy lotus tubers online, or at a local nursery or garden center. Because of difficulty shipping, they are typically not available after they break dormancy in late spring. However, you may be able to buy some that have been grown locally.^{[10]
X
Research source}
- For rarer hybrids, you may have to shop online. If there is a water gardening society with a chapter near you, ask them for recommendations. Some societies also sell plants themselves.^{[11]
  X
  Research source}
2
Float the tuber in a bowl in water between 75 and 87 °F (24 and 31 °C). Place your tuber gently on the surface of the water. Place your bowl near a warm, sunny window, but out of direct sunlight.^{[12]
X
Research source}
- If you're planning on moving the lotus to a pond, use water from the pond (as long as it's warm enough). Change the water every 3 to 7 days, or if it starts to appear cloudy.
3
Choose a round container 3 to 4 ft (0.91 to 1.22 m) in diameter. If set loose, a lotus will grow as large as the area in which it is planted. Your container reins the lotus in and keeps it from taking over your whole pond.^{[13]
X
Research source}
- A deep container will decrease the chance that your lotus spills over the top and spreads across the pond. Round containers keep your lotus from getting jammed up in a corner, which can stunt or kill the plant.
4
Fill your container with dense soil. A good potting medium for lotus is a soil mixture about 60 percent clay and 40 percent river sand. Leave about 3 to 4 inches (7.6 to 10.2 cm) between the top of the soil and the rim of your container.^{[14]
X
Research source}
- You can also use amended soil, with a separate layer of sand 2 to 3 inches (5.1 to 7.6 cm) deep on top. Make sure there is still sufficient space between the top of the sand layer and the rim of your container.
5
Press the tuber into the top of the soil. Embed your tuber slightly in the sand, then carefully weigh it down with rocks so that it won't float up to the surface of the water before it takes root.^{[15]
X
Research source}
- Do not bury the tuber completely in the soil – it will rot. Make sure it's embedded only slightly at the surface.
6
Lower your container 6 to 12 in (15 to 30 cm) below the surface of your pond. Choose a sunny spot for your lotus that is away from flowing water and will give your lotus enough room to grow. Once your tuber is secured in place, you can lower it into the location you've chosen to plant your lotus.^{[16]
X
Research source}
- Once seated in the pond, the tuber plants itself by turning downward into the soil mixture and growing roots.

Method 3

Method 3 of 3:

Caring for Your Lotus

1
Maintain a water temperature of at least 70 °F (21 °C). Active growth begins when the surface water reaches this temperature. Your lotus needs warm water to grow to its fullest potential. Ideally, the air temperature should be at least 70 °F (21 °C) as well.^{[17]
X
Research source}
- The lotus will start to send up leaves after a few days in water above 70 °F (21 °C). It blooms after 3 to 4 weeks in water above 80 °F (27 °C).
- Check your water temperature every other day. If you live in a cooler climate, you may need a heater for your pond to maintain the appropriate temperature.^{[18]
  X
  Research source}
2
Keep your lotus in direct sunlight. Lotus plants thrive in full sun, requiring at least 5 to 6 hours of direct sunlight per day. If your pond is partially shaded, you may want to prune or remove surrounding foliage that blocks out the sun.^{[19]
X
Research source}
- In North America, the lotus typically blooms from mid-June or mid-July through early autumn. The blossoms open early in the morning and start closing mid-afternoon. Individual blossoms last 3 to 5 days, then molt. The process repeats through the remaining months of active growth.
3
Prune dying blossoms and yellow or damaged leaves. If your lotus starts to take over your pond, you can also cut away new growth, but keep in mind it will grow again until the lotus is repotted in spring.^{[20]
X
Research source}
- Never cut flower or leaf stems below water level. Roots and tubers use stems for oxygen.^{[21]
  X
  Research source}
4
Use pond tabs to fertilize your lotus. Pond tablets are fertilizer made especially for aquatic plants. Wait until your tuber has developed at least 6 leaves before fertilizing it, and don't place the fertilizer directly against the tuber itself.^{[22]
X
Research source}
- Small lotus varieties only need 2 tablets, while larger varieties may need as many as 4. Add fertilizer once every 3 or 4 weeks, stopping in mid-July. If you continue to fertilize your lotus past this point, it won't be able to prepare for dormancy.
- If you grew your lotus from seed, don't fertilize it during its first year.
5
Watch for pests. While pests vary depending on your geographic location, aphids and caterpillars may be attracted to lotus leaves. Applying a small amount of powdered pesticide directly to the leaves will protect your lotus plant from these pests.^{[23]
X
Research source}
- Liquid pesticides, even organic ones, have oils and detergents that can damage your lotus.
6
Move your lotus to deeper water in the fall. Lotus plants can spend the winter in ponds as far north as Michigan or Minnesota as long as the pond is deep enough to protect the tubers from ice. The tuber should at least be below the frost line, a depth that varies depending on where you live.^{[24]
X
Research source}
- If your pond is relatively shallow, you can remove the container and leave it in a garage or basement until spring. Mulch around any above-ground pots to keep the tubers warm.
7
Repot the tuber every year. In early spring, when you spot the first sign of new growth, give your lotus fresh soil and return it to the original container (unless the container is damaged). Replace it in your pond at the same depth it was before.^{[25]
X
Research source}
- If your lotus took over your pond the previous year, inspect the container for cracks. You may want to get a larger container to better hold the lotus, if it grew over the rim.

Community Q&A

Question

Can a lotus grow in indirect sunlight?

Community Answer

Yes.
Question

After sprouting, the plant seed became dry and finally dead, although every day I changed the water. Why?

Community Answer

Next time try soaking all seeds in potassium permanganate for five minutes just before planting. This will kill off many of the microscopic organisms that cause early plant die off. Mix just enough PP into a small amount of water to turn the water dark purple. You can also use PP to sterilize the soil, but it should be rinsed before using it. Another option is just baking the soil in an oven to 250 F. Keep seedling submerged in pond water (not chlorinated) until it opens leaves on the water. If your area is extremely dry, you may not be able to keep the young plants alive; all lotus originate in humid conditions.
Question

How do I scar the seeds?

Community Answer

You can simply nick with a knife until you see some white.