This wikiHow teaches you how to cancel your OnStar service, as well as how to prevent OnStar from collecting your driving data after cancellation. Although you can simply unsubscribe from the service, the OnStar hardware continues to track how you use your vehicle, even if you remove its fuse. The only way to completely eliminate OnStar is to physically disconnect the module from your vehicle. Other than the OnStar system and its related services (Automatic Crash Response and Emergency Services), no other system in the vehicle should stop working when you disconnect the module.

Steps

  1. 1
    Ask OnStar Customer Service to cancel your subscription. If you want to stop using OnStar, dial 1-888-4-ONSTAR (1-888-466-7827), or press the blue button on your OnStar system to contact Customer Service. The agent you speak with will be able to guide you through the process of canceling your service. You may need to provide certain information during the process, such as contact or billing information.
    • Even after your service is cancelled, OnStar can continue to collect data from your vehicle for its marketing and other purposes.[1] To prevent OnStar from having access to your driving information, continue with this method to learn how to physically disconnect the OnStar module.
  2. 2
    Turn the vehicle off. Also, if you haven't already engaged the parking brake, do so before you continue.
    Advertisement
  3. 3
    Open the trunk. In most vehicles, the OnStar module is mounted to the back of either the right or left rear wheel well, both of which can be accessed through the trunk. In other vehicles, the module may be found behind the glove box or (in some larger trucks) under a wide plastic panel below the stereo.[2]
    • If you know that your OnStar is behind the glove box, remove the glove box from the vehicle and skip to step 7. To remove the glove box, open its door and remove any tabs or cords securing it into place. Then, with a hand on either side of the box, push in on both walls to narrow the sides and slide it free.[3]
    • If the module is in the dash below the stereo, use a plastic auto trim/molding-removal tool (available from an auto supply store) to pry the panel from the dashboard, and then gently pull the panel free. You should be able to slide the silver metal OnStar module its mount without having to unscrew anything. Skip down to step 7 once you see the silver box in the panel.[4]
  4. 4
    Remove the trunk's liner. The liner isn't secured by any screws or nuts, so you should be able to easily lift it out from the trunk. Just grab it from one edge and lift it upward.
    • After removing the liner, set it aside and look at the newly revealed space. If your vehicle has space for the spare tire, you should see that space and/or the spare tire after removing the liner.
  5. 5
    Lift out the spare tire. If your vehicle has a spare tire in it, you will need to remove it from the trunk and set it aside for now.[5]
    • In some cases, there might be a nut in the center of the spare tire compartment holding the tire in place. Use a screwdriver and twist the nut counterclockwise to remove it. After removing the nut, lift out the tire.
  6. 6
    Remove the sill plate. Locate four screws near the four corners of the trunk. Remove these screws and lift out the sill plate.
    • If your vehicle has a cargo net in the trunk, you only need to remove the four screws securing the net. Remove both the net and the sill plate.
    • If your vehicle does not have a cargo net in the trunk, the four screws you need to remove should be located in the corners of your trunk.
    • After removing the screws, pull the sill plate up to lift it out of the trunk. Set it and the screws aside in a safe spot while you continue working.
  7. 7
    Pull away the right-side panel. Grab the front of the shell panel on the side of the trunk, and then pull away enough to reveal the interior contents. You should see a silver metal box inside, which is the OnStar unit.
    • Pull the panel forward just enough so that it clears the stud located in the back lip of the trunk. After pulling it forward, carefully pull it toward the middle of the trunk, revealing the compartment beneath it.
    • Don't remove the panel completely! You can disconnect the OnStar without using any tools to remove additional paneling.
  8. 8
    Identify the OnStar box. The Onstar control box should be a small metal box attached to the side of the vehicle (if in the trunk) or inside the plastic paneling (in the dash or behind the glove box). It will usually have an OnStar or LG logo. Don't remove the box.
    • If you do not see the module on the right side, try the left side of the trunk.
  9. 9
    Unplug all three connectors. Locate the three cable connectors on the bottom of the silver box. To unplug a connector, grip its base with two fingers and press them inward, and then pull the plug straight out. Repeat until there are no cables connected to the silver box.[6]
    • These three cables provide power to the system and allow the system to communicate with OnStar. Pulling them out should shut down the system and block any additional communication.
  10. 10
    Coil up the cables. Wind up the three cables and tie them loosely together with cable ties. Position the coil above or beneath the OnStar control box.[7]
    • Coiling the cables will prevent them from getting in the way. It will also make it easier to access the cables again in case you need to reconnect them at some point.
  11. 11
    Return the vehicle to its original state. Work in reverse steps to return all of the removed covers and parts to the trunk, dash, or glove box.
  12. 12
    Check the system. Start your vehicle's ignition. Pressing the OnStar button beneath the rearview mirror should now result in dead air. If the OnStar light was previously on, it should now be off.
    • You should also check your other vehicle systems to make sure that none of them were affected. Turn on all lights, radios, and other electric features. Verify that there are no warning lights displayed.
  13. Advertisement

Community Q&A

  • Question
    Is OnStar a vehicle tracking system?
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    Due to the GPS component of OnStar, it can be used as a vehicle tracking system, which the company states is helpful for emergency situations (such as when the driver has an accident and is not responsive) and security (such as tracking stolen vehicles). It is meant to be covered by privacy protocols but some surveillance issues have concerned consumer and privacy organizations (Wikipedia, 2019).
  • Question
    Can OnStar GPS be disabled?
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    Yes, it is possible to do this either by disconnecting the fuse or the control box. The instructions for doing either are explained in the steps above.
  • Question
    How do I cancel my OnStar account?
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.
    wikiHow Staff Editor
    wikiHow Staff Editor
    Staff Answer
    To cancel your OnStar account, contact the company. To do this, either press the blue button on the OnStar system in your vehicle or call by phone on 1-888-4-ONSTAR. The staff at OnStar will talk you through the cancellation process.
Advertisement

About This Article

Nicole Levine, MFA
Written by:
wikiHow Technology Writer
This article was co-authored by wikiHow staff writer, Nicole Levine, MFA. Nicole Levine is a Technology Writer and Editor for wikiHow. She has more than 20 years of experience creating technical documentation and leading support teams at major web hosting and software companies. Nicole also holds an MFA in Creative Writing from Portland State University and teaches composition, fiction-writing, and zine-making at various institutions. This article has been viewed 367,132 times.
106 votes - 82%
Co-authors: 12
Updated: June 27, 2021
Views: 367,132
Categories: Car Electronics
Article SummaryX

1. Call 1-888-4-ONSTAR to cancel.
2. Open the trunk.
3. Remove the trunk liner and spare tire.
4. Remove the sill plate and net.
5. Remove the right side panel.
6. Remove the three cables from the OnStar module.
7. Reassemble the vehicle.

Did this summary help you?
Advertisement