How to Make a Dizi

Measure and cut the material you are using for the flute body. If you are using bamboo, measure a length of bamboo that is approximately 18-20” long, starting from just before one of the fibrous partitions of the bamboo stalk (this will be one of your ends). Mark it all the way around the stalk. Measure 18-20” from this line and make another mark all the way around the stalk. There should be at least a couple of fibrous partitions between each end, including the very last partition on one end. Cut both ends clean with a saw.

Mark the holes. Decide which side the top of your flute will be. Starting from the blocked end of your flute, measure 1” along the top and mark a hole (this is the mouth opening, or embouchure). Measure 3” from this first hole and mark a hole (this is the mokong hole, which will be covered by a dimo membrane). Measure another 3” from this mokong hole, and mark another hole (this is the first finger hole). Continuing on at 1” intervals from there, measure and mark another 5 holes for finger holes. You should end up with one mouth opening, one mokong, and 6 finger holes. These holes will end up being about ¼” in diameter.^[5]

Burn out the inside for bamboo flutes. Burn out the inside to remove any fibrous material that might be inside the bamboo, stalk. Heat a ½” steel rod in a fire (do not use a kitchen oven) and hold the unheated end of the rod with protective oven mitts, as it will be very hot. Carefully insert the steel rod into the bamboo stalk, but do not poke it all the way through. Leave the blocked end intact. Twist the steel rod a few times to burn off any excess material inside the stalk. Remove the steel rod.

Burn the hole marks. Using protective oven mitts and vice grips, heat a ¼” drill bit in a fire (again, do not use a kitchen oven). Place the tip of the drill bit on top of each hole you marked. Twist gently to burn away the wood, but do not push it all the way through the hole (this may cause the bamboo to crack).

Sand through the holes. Roll up a piece of 3x3 fine-grit sandpaper into a tube and place the end on top of one of the burned holes.^[6] Twist it back and forth to sand away the burned spots. The sandpaper tube should go through the hole and make the opening. Sand a little more on the mouth opening to make this opening slightly larger, but be careful to not make it too wide. It should only be about ¼” to 3/8” in diameter.

Sandpaper your flute. Using a fine-grained sandpaper, sand carefully along the body of the flute. Spread out some newspaper on your work area to catch the dust. Take extra care around the mouth opening, finger holes, and ends. Sand the flute until it is smooth to the touch.

Choose carvings you want to have on your dizi. Most dizi makers will carve their initials into the body of the dizi, and others will also include a Chinese poem or other saying along the body. The key of the dizi is typically carved into the flute next to the third finger hole.

Choose a finish for your dizi. Some dizis are lacquered or painted, while others are natural and bare. One option is to use linseed oil to coat and finish the dizi.^[7] Pour a little bit of linseed oil on an old rag and gently rub it into the body of the flute. Allow it to dry before adding accessories, attaching the dimo membrane, or playing the flute.

Choose accessories for your dizi. These can be purchased at Asian markets or online. Attach a silk tassel to the bottom hole of the dizi. Red is typically a color associated with good fortune in China and can be an appropriate color choice for a tassel.

Choose the material for your dimo membrane. Traditional dimo is made from a thin internal membrane from bamboo. Other useable materials are garlic skin, rice paper, cigarette paper, or other very thin papers. Dimo paper is available from online music supply stores. You can use clear tape as an alternative material, but this won’t produce the best sound.

Gather your supplies. These include small, sharp scissors, water, Erjiao (a traditional Chinese flute glue) or other water-soluble adhesive, the dimo membrane, and the dizi body. Erjiao can be purchased from online music supply stores.

• Water-soluble glue, such as the glue specifically intended for adhering the dimo, is preferred, since you may need to adjust the placement of the dimo from time to time. If you use an adhesive that hardens, it will crack when you try to move the dimo, thereby ruining the membrane.

Measure and cut the dimo. The dimo will be placed on the second hole from the top of the dizi (this hole is called the mokong). Place the dimo paper over this hole and add at least 0.5 centimeter (0.2 in) on all sides of the hole. Cut the membrane to these specifications.

Apply glue to the dizi. Dip your finger in some water and rub glue on your finger. Apply this glue around the hole where you will place the dimo. Swab any residual glue away from the hole itself and the very edge of the hole. Glue on the membrane over the hole will disrupt the vibration of the membrane.

• Another option is to use garlic juice to produce a sticky, water-soluble adhesive. Peel one garlic clove and gently rub the freshly cut garlic across the membrane hole. This will leave some adhesive material.^[8]

Gently place the dimo over the hole. Line up the dimo so it is even on all sides. Pinch the flute on either side of the hole with your fingers touching the dimo. Move your fingers up and down a few times gently to create lateral wrinkles in the dimo. The wrinkles should be evenly spaced on the dimo. If the dimo is completely smooth, the dizi will sound dull. If the dimo is not taut, even if it has wrinkles, the dizi may sound bright but may not emit any sounds at all from time to time, becoming unpredictable.

Test the dizi. Blow into the dizi to check the sound created by the dimo. Tap on the dimo a few times while you play to help it settle into place. The dimo should start vibrating when you play.

• The membrane will cause the sound of the dizi to be lowered when played. It also limits the playability of high notes.
• You can use the same dimo for several months on a dizi, but you may need to make minor adjustments as you continue to play.
• Do not get discouraged if you have difficulties with the dimo. It takes skill and practice to apply the membrane correctly in order to achieve the best possible sound from the dizi.

Hold the flute horizontal to your body and place your lips next to the mouth opening. Place three fingers from one hand on the top three holes and three fingers from the other hand on the bottom three holes. Blow over the flute as you would a soda pop bottle, pursing your lips and directing air into the mouth opening. If you are not getting any sound, try pursing your lips even tighter so that the air hole is smaller.

• Since the dizi is symmetrical, it can be held in either horizontal direction, and can be played easily by a left-handed person as by a right-handed person.

Consider the season and temperature when you play. A dizi can emit different tones depending on temperature and humidity, so oftentimes winter is a less desirable season to play certain dizis.

Practice in front of a mirror. Watch the shape that your mouth makes as you are playing. Take note of how your mouth looks when you are able to make noise with the flute.

Consult instructions and courses online. There are many different resources online that give instruction on how to play the dizi. Tim Liu is one of the most well-known dizi instructors, although there are a number of others as well.^[9] , ^[10]

Learn advanced techniques. Once you have mastered how to play a dizi, you can start to experiment with other techniques, such as sliding and popping notes, creating two tones simultaneously, using different tonguing techniques, using circular breathing, and so on, which can be accomplished by changing the embouchure and airflow.^[11] These are difficult to achieve, so a beginner should certainly not expect to be an expert player immediately. Dizi musicians spend decades perfecting their techniques.

• Master dizi players typically use several dizis to be able to play in a range of keys.

Wipe the dizi dry after playing. After you have finished playing the dizi, use a soft cloth to wipe it dry. You may use a long rod to push a cloth inside the dizi to catch excess moisture.

Store the dizi in a dedicated case. Cloth bags, plastic airtight bags, or hard-covered soft-lined cases are ideal containers in which to store a dizi.

Avoid swift temperature changes. Bamboo flutes are susceptible to expanding or contracting depending on temperature and humidity. Do not place in direct sunlight such as on a windowsill, as this will likely lead to cracked bamboo. If you are taking the dizi outside on a cold day, allow the flute to acclimatize before playing it.

Eliminate any growth of fungus. Since moisture may gather in the dizi, even if you’ve dried it, fungus spores may start to grow. Use food grade hydrogen peroxide to spot clean the flute to eliminate fungus growth.